Performance comparison of various types of embankment dams in relation to the conditions of the Mullalakh HPP
Open Access
- 1 February 2021
- journal article
- Published by Moscow State University of Civil Engineering in Vestnik MGSU
- Vol. 16 (2), 202-219
- https://doi.org/10.22227/1997-0935.2021.2.202-219
Abstract
Introduction. Several types of embankment dams are used in the hydraulic engineering practice. However, the choice of a dam is individual for each hydraulic engineering project, as it takes account of specific features and natural conditions. This paper compares two types of rockfill dams (the one having a concrete face and the other having an asphalt-concrete diaphragm) in relation to the Mullalakh HPP on the Pskem River in the Republic of Uzbekistan. The dam height is 85 m. The comparison was performed from the standpoint of the dam performance in case of exposure to static forces and high seismicity. Materials and methods. The analysis of (1) the stress-strain state (SSS), (2) the stability of slopes exposed to regular and irregular load combinations was conducted for two types of dams. All calculations were performed in the two-dimensional domain. The analysis of the stress-strain state took account of the non-linear behavior of the soil ground and the contact interaction between structural elements. Seismic loads, included into the scope of irregular loads, were identified using the response spectrum method applied to particular periods and self-oscillation modes. Slope stability was analyzed with regard for the stress state of soils identified in the course of SSS calculations. Results. Each type of embankment dams has its specific features. The asphalt diaphragm dam is worse at perceiving high seismic loads. Its SSS during an earthquake features strength loss and emergence of soil discontinuity zones. The disadvantage of a concrete face dam is the insufficient safety of its anti-seepage element. Supplementary measures are needed to ensure the appropriate stress state of the face. Another finding is that the slopes of both types of dam do not demonstrate a sufficient stability factor, if the slope ratio equals to 1.5 during a 9-point earthquake. Conclusions. In high seismicity regions, a concrete faced dam demonstrates better performance than the asphalt diaphragm dam if both are exposed to static and seismic forces.Keywords
This publication has 12 references indexed in Scilit:
- Design and performance of the Quxue asphalt-core rockfill damSoils and Foundations, 2020
- Improvement Methods for Reduction of the High Stress of Ultra-High Asphalt Concrete Core DamsApplied Sciences, 2019
- Investigation for the key technologies of ultra-high asphalt concrete core rockfill damsSoils and Foundations, 2019
- Long-term deformation analysis of Shuibuya concrete face rockfill dam based on response surface method and improved genetic algorithmWater Science and Engineering, 2019
- Stress-Strain State in the Deformation of the Rogun Dam During the Construction PeriodPower Technology and Engineering, 2018
- Analysis and Prediction of Asphalt-Concrete Core Wall Settlement of the Boguchany HPP Rockfill Dam During the Period of Construction CompletionPower Technology and Engineering, 2017
- Technical Progress on Researches for the Safety of High Concrete-Faced Rockfill DamsEngineering, 2016
- Stress-strain analysis of Aikou rockfill dam with asphalt-concrete coreJournal of Rock Mechanics and Geotechnical Engineering, 2011
- Design and performance of the Yele asphalt-core rockfill damCanadian Geotechnical Journal, 2010
- Analyze on Development Prospects of 300m Level Ultra-high CFRD from Shuibuya High CFRDPublished by Institute of Electrical and Electronics Engineers (IEEE) ,2010