A Thermoelectric Energy Generator With Double Cavity Design by Single Polysilicon Layer in Standard CMOS Process
- 14 September 2021
- journal article
- research article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Sensors Journal
- Vol. 21 (21), 23799-23805
- https://doi.org/10.1109/jsen.2021.3111903
Abstract
The performance of a thermoelectric energy generator (TEG) can be improved by having thermocouple materials with higher Seebeck coefficient, thermocouple configuration with better thermal isolation, and thin-film layer deposition/etching with effective electrical insulation. A TEG design by the 1P6M (1 polysilicon layer and 6 metal layers) standard CMOS process in semiconductor foundry service (TSMC) is proposed in this work to achieve better energy harvesting performance. The in-plane thermocouple has higher Seebeck effect by the single polysilicon layer at different doping rates. The TEG configuration is with double cavity design to seal the thermocouples above-and-below for better thermal isolation, and the deposition layers are in mask-less design for better electrical insulation. Measurement results of a $5\times5$ mm 2 TEG chip show that higher thermoelectric conversion, better thermal isolation and electrical insulation can be realized. The voltage factor 15.604 V/cm 2 K and power factor $0.105~\mu \text{W}$ /cm 2 K 2 are about $5.40\times $ and $2.34\times $ , respectively, of those of the previous work by the CMOS process with two polysilicon layers. This design, implementation, and experiment have achieved the best performance in all TEGs by CMOS process in semiconductor foundry.
Funding Information
- Ministry of Science and Technology, Taiwan (109-2221-E006-116)
- Taiwan Semiconductor Research Institute for CMOS Process
This publication has 23 references indexed in Scilit:
- Design of Low Voltage Low Power DC–DC Converters Using Adiabatic TechniqueJournal of Circuits, Systems and Computers, 2018
- Silicon-Based Monolithic Planar Micro Thermoelectric Generator Using Bonding TechnologyJournal of Microelectromechanical Systems, 2016
- CMOS MEMS-based thermoelectric generator with an efficient heat dissipation pathJournal of Micromechanics and Microengineering, 2012
- Application of quantum well-like thermocouple to thermoelectric energy harvester by BiCMOS processSensors and Actuators A: Physical, 2011
- Fabrication and evaluation of microscale thermoelectric modules of Bi2Te3-based alloysJournal of Micromechanics and Microengineering, 2010
- Design and verification of a thermoelectric energy harvester with stacked polysilicon thermocouples by CMOS processSensors and Actuators A: Physical, 2010
- Design, Fabrication, and Characterization of CMOS MEMS-Based Thermoelectric Power GeneratorsJournal of Microelectromechanical Systems, 2010
- Development of a thermoelectric energy harvester with thermal isolation cavity by standard CMOS processSensors and Actuators A: Physical, 2009
- Design and optimization of wafer bonding packaged microelectromechanical systems thermoelectric power generators with heat dissipation pathJournal of Vacuum Science & Technology B: Microelectronics and Nanometer Structures, 2009
- Micromachined CMOS thermoelectric generators as on-chip power supplySensors and Actuators A: Physical, 2004