Development of Mathematical Model for Percentage of Elongation of TIG Welded Duplex Stainless Steel
Open Access
- 5 February 2022
- journal article
- Published by Asian Research Association in International Research Journal of Multidisciplinary Technovation
Abstract
Quality strongly depends on good mechanical properties of any manufacturing material. Similarly, quality of Tungsten Inert Gas (TIG) welding of Duplex Stainless Steel (DSS) depends on good mechanical properties like percentage of elongation, ultimate tensile strength etc. Better Percentage of Elongation (PE) is produced using proper welding parameters and their values at the time of TIG welding. In this study, TIG welding has been done on ASTM/UNS 2205 duplex stainless steel materials. A new mathematical model is developed using non-linear regression analysis for the prediction of percentage of elongation. The variables used in the prediction models are selected welding parameters like welding current, gas flow rate and speed of welding. A residual plot for PE has been developed to validate the mathematical model. Calculation of percentage deviation for PE has been made. Comparison of measured and predicted PE value has been done by graphical representation. The relationship between percentage of elongation and the welding parameters has been illustrated graphically by surface plots and contour plots as well. Combined effects of any pair of input parameters on PE are represented graphically with the help of three-dimensional surface plots. According to this analysis, the models provide good PE with the data used in this study.Keywords
This publication has 11 references indexed in Scilit:
- Developments of mathematical models for prediction of tensile properties of dissimilar AA6061-T6 to Cu welds prepared by friction stir welding process using Zn interlayerSādhanā, 2018
- Texture, microstructure and anisotropic properties in annealed 2205 duplex stainless steel weldsMaterials Characterization, 2011
- Comparative analysis of TIG welding distortions between austenitic and duplex stainless steels by FEMApplied Thermal Engineering, 2010
- Phase transformation and mechanical behavior in annealed 2205 duplex stainless steel weldsMaterials Characterization, 2008
- Sensitivity Analysis for Process Parameters in Cladding of Stainless Steel by Flux Cored Arc WeldingJournal of Manufacturing Processes, 2006
- The use of grey-based Taguchi methods to determine submerged arc welding process parameters in hardfacingJournal of the American Academy of Dermatology, 2002
- The Use of Fuzzy Logic in the Taguchi Method for the Optimisation of the Submerged Arc Welding ProcessThe International Journal of Advanced Manufacturing Technology, 2000
- Optimisation of the weld bead geometry in gas tungsten arc welding by the Taguchi methodThe International Journal of Advanced Manufacturing Technology, 1998
- Textures and microstructures in duplex stainless steelMaterials Science and Technology, 1994
- Effect of submerged arc process variables on dilution and bead geometry in single wire surfacingJournal of the American Academy of Dermatology, 1993