Analysis of Multi-Stage Running-In Process of Sn-11Sb-6Cu Alloy and AISI 1045 With Phase Trajectory Plot
- 8 September 2021
- journal article
- research article
- Published by ASME International in Journal of Tribology
- Vol. 144 (6), 1-14
- https://doi.org/10.1115/1.4052217
Abstract
Running-in of the main bearings of diesel engine is a crucial process before service. Multi-stage running-in is a better way to enhance running-in quality and efficiency. In order to reveal the evolution of phase trajectory and compare the running-in quality, the running-in tests were performed with the material of bearing bush (Sn-11Sb-6Cu) and shaft (AISI 1045). The running-in quality was comprehensively evaluated via friction coefficient, phase trajectory and surface topography. Results indicate that the phase trajectories show a trend of stage-by-stage convergence. The multi-stage running-in can achieve a more stable attractor, lower friction coefficient and smoother surface, that is, a better running-in quality than the constant running-in scheme. This study provides a reference for formulating running-in specifications for sliding bearings.Keywords
Funding Information
- National Natural Science Foundation of China (51705216, 52005226)
- Natural Science Foundation of Jiangsu Province (BK20190971)
This publication has 25 references indexed in Scilit:
- Development of prediction models of running-in attractorTribology International, 2018
- The effect of contact pressure and surface texture on running-in behavior of case carburized steel under boundary lubricationWear, 2017
- Running-in and micropitting behaviour of steel surfaces under mixed lubrication conditionsTribology International, 2016
- How common is the steady-state? The implications of wear transitions for materials selection and designWear, 2015
- Wear identification in rotor-bearing systems by measurements of dynamic bearing characteristicsComputers & Structures, 2011
- Principal component analysisWIREs Computational Statistics, 2010
- Experimental study of the effect of additive on the tribological properties journal bearing under running‐in and start‐up or shut‐down stagesIndustrial Lubrication and Tribology, 2008
- Independent coordinates for strange attractors from mutual informationPhysical Review A, 1986
- Detecting strange attractors in turbulencePublished by Springer Science and Business Media LLC ,1981
- Geometry from a Time SeriesPhysical Review Letters, 1980