Numerical Simulation of the Cold Spray Deposition of Copper Particles on Polyether Ether Ketone (PEEK) Substrate
- 27 August 2021
- journal article
- research article
- Published by Springer Science and Business Media LLC in Journal of Thermal Spray Technology
- Vol. 30 (7), 1792-1809
- https://doi.org/10.1007/s11666-021-01254-3
Abstract
No abstract availableKeywords
This publication has 43 references indexed in Scilit:
- Influence of Particle Initial Temperature on High Velocity Impact Process in Cold SprayingProcedia Environmental Sciences, 2012
- Influence of strain rate, temperature and adiabatic heating on the mechanical behaviour of poly-methyl-methacrylate: Experimental and modelling analysesMaterials & Design (1980-2015), 2012
- Ballistic performance of multi-layered metallic plates impacted by a 7.62-mm APM2 projectileInternational Journal of Impact Engineering, 2011
- Deposition of metallic coatings on polymer surfaces using cold spraySurface and Coatings Technology, 2010
- General aspects of interface bonding in kinetic sprayed coatingsActa Materialia, 2008
- Temperature dependence of the tribological mechanisms of amorphous PEEK (polyetheretherketone) under dry sliding conditionsActa Materialia, 2008
- Adiabatic shear instability based mechanism for particles/substrate bonding in the cold-gas dynamic-spray processMaterials & Design (1980-2015), 2004
- Role of plasticity in heat generation during high rate deformation and fracture of polycarbonateInternational Journal of Plasticity, 2002
- On the conversion of plastic work to heat during high strain rate deformation of glassy polymersMechanics of Materials, 1999
- The high temperature and high strain-rate behaviour of a plain carbon and an HSLA steelJournal of Mechanical Working Technology, 1987