Coulomb-actuated microbeams revisited: experimental and numerical modal decomposition of the saddle-node bifurcation
Open Access
- 28 May 2021
- journal article
- research article
- Published by Springer Science and Business Media LLC in Microsystems & Nanoengineering
- Vol. 7 (1), 1-13
- https://doi.org/10.1038/s41378-021-00265-y
Abstract
Electrostatic micromechanical actuators have numerous applications in science and technology. In many applications, they are operated in a narrow frequency range close to resonance and at a drive voltage of low variation. Recently, new applications, such as microelectromechanical systems (MEMS) microspeakers (µSpeakers), have emerged that require operation over a wide frequency and dynamic range. Simulating the dynamic performance under such circumstances is still highly cumbersome. State-of-the-art finite element analysis struggles with pull-in instability and does not deliver the necessary information about unstable equilibrium states accordingly. Convincing lumped-parameter models amenable to direct physical interpretation are missing. This inhibits the indispensable in-depth analysis of the dynamic stability of such systems. In this paper, we take a major step towards mending the situation. By combining the finite element method (FEM) with an arc-length solver, we obtain the full bifurcation diagram for electrostatic actuators based on prismatic Euler-Bernoulli beams. A subsequent modal analysis then shows that within very narrow error margins, it is exclusively the lowest Euler-Bernoulli eigenmode that dominates the beam physics over the entire relevant drive voltage range. An experiment directly recording the deflection profile of a MEMS microbeam is performed and confirms the numerical findings with astonishing precision. This enables modeling the system using a single spatial degree of freedom.Keywords
This publication has 47 references indexed in Scilit:
- Size-dependent pull-in instability of electrostatically actuated microbeam-based MEMSJournal of Micromechanics and Microengineering, 2011
- Pull-in and snap-through instabilities in transient deformations of microelectromechanical systemsJournal of Micromechanics and Microengineering, 2009
- Building CMUTs for imaging applications from top to bottomMicroelectronic Engineering, 2007
- A 5-GHz CMOS Double-Quadrature Receiver Front-End With Single-Stage Quadrature GeneratorIEEE Journal of Solid-State Circuits, 2004
- A novel NO/sub 2/ gas sensor based on bis[phthalocyaninato] samarium complex/silicon hybrid charge-flow transistorIEEE Sensors Journal, 2003
- Fabrication, characterization, and analysis of a DRIE CMOS-MEMS gyroscopeIEEE Sensors Journal, 2003
- Characterization of the mechanical behavior of an electrically actuated microbeamJournal of Micromechanics and Microengineering, 2002
- Generating efficient dynamical models for microelectromechanical systems from a few finite-element simulation runsJournal of Microelectromechanical Systems, 1999
- A fast incremental/iterative solution procedure that handles “snap-through”Computers & Structures, 1981
- The coalescence of closely spaced drops when they are at different electric potentialsProceedings of the Royal Society of London. Series A - Mathematical and Physical Sciences, 1968