Long-Exposure RGB Photography with a Fixed Stand for the Measurement of a Trajectory of a Dynamic Impact Device in Real Scale
Open Access
- 14 October 2021
- Vol. 21 (20), 6818
- https://doi.org/10.3390/s21206818
Abstract
The present manuscript proposes a novel method for the measurement of a trajectory of a falling impact hammer in the dynamic loading of conveyor belts and the determination of their impact resistance. The proposed method has been experimentally tested and the results of the measurements are presented in this manuscript. The proposed method is based on the long-exposure photography with a long-duration opened shutter of the Nikon D5000 DSLR camera. Results of the experimental research were compared with direct reference measurements performed using the L-GAGE LT3 laser distance sensor. Differences between values, obtained by the new method and by the reference measurements were up to ±3 mm. The standard deviation identified in all the experiments was 1 mm.Keywords
Funding Information
- NATIONAL RESEARCH AGENCY OF SLOVAKIA (VEGA 1/0429/18, VEGA 1/0588/21, 004TUKE-4/2019, 055TUKE-4/2021)
- Slovak Research and Development Agency (APVV-18-0351)
This publication has 27 references indexed in Scilit:
- Developments of rubber material wear in conveyer belt systemTribology International, 2017
- Suppression of Systematic Errors of Electronic Distance Meters for Measurement of Short DistancesSensors, 2015
- Precise deformation measurement of prestressed concrete beam during a strain test using the combination of intersection photogrammetry and micro-network measurementPublished by SPIE-Intl Soc Optical Eng ,2015
- Correlation of rubber based conveyor belt properties and abrasive wear rates under 2- and 3-body conditionsWear, 2014
- Fault tree analysis of failure cause of crushing plant and mixing bed hall at Khoy cement factory in IranCase Studies in Engineering Failure Analysis, 2014
- Optimum conditions for vulcanizing a fabric conveyor belt with better adhesive strength and less abrasionMaterials & Design (1980-2015), 2012
- Optimum conditions for field vulcanizing a fabric conveyor belt with a better capability of elongationMaterials & Design (1980-2015), 2012
- Analysis of the ageing impact on the strength of the adhesive sealed joints of conveyor beltsJournal of the American Academy of Dermatology, 2008
- A Computational Approach to Edge DetectionPublished by Elsevier BV ,1987
- A Computational Approach to Edge DetectionIEEE Transactions on Pattern Analysis and Machine Intelligence, 1986