Corrosion of titanium alloys in pressurised water at 350 °C and 17.5 MPa
- 1 June 2022
- journal article
- research article
- Published by Elsevier BV in Corrosion Science
Abstract
No abstract availableKeywords
This publication has 12 references indexed in Scilit:
- Understanding crystallographic orientation dependent dissolution rates of 90Cu-10Ni alloy: New insights based on AFM/SKPFM measurements and coordination number/electronic structure calculationsCorrosion Science, 2019
- Oxide formation on titanium alloys in primary water of nuclear pressurised water reactorCorrosion Science, 2019
- Automated crystal orientation and phase mapping in TEMMaterials Characterization, 2014
- Influence of Fe and Al doping on the stabilization of the anatase phase in TiO2nanoparticlesJournal of Materials Chemistry C, 2014
- A New Model to Predict the Oxidation Kinetics of Zirconium Alloys in a Pressurized Water ReactorJournal of ASTM International, 2008
- Grain dependent electrochemical investigations on pure iron in acetate buffer pH 6.0Electrochimica Acta, 2006
- Ti(IV) hydrolysis constants derived from rutile solubility measurements made from 100 to 300°CApplied Geochemistry, 2001
- Revised pourbaix diagrams for iron at 25–300 °CCorrosion Science, 1996
- The solubility of magnetite and the hydrolysis and oxidation of Fe2+ in water to 300°CJournal of Solution Chemistry, 1980
- Phase Transformation Studies in TiO2 Supporting Different Defect Mechanisms in Vacuum-Reduced and Hydrogen-Reduced RutileJournal of Applied Physics, 1964