Influence of surcharge on cone penetration test results and the inspection of various approaches for capturing its effect: a case study
Open Access
- 7 June 2021
- journal article
- research article
- Published by Springer Science and Business Media LLC in International Journal of Geo-Engineering
- Vol. 12 (1), 1-19
- https://doi.org/10.1186/s40703-021-00146-3
Abstract
Studies in recent decades demonstrate the significant effect of stress configuration (e.g., vertical stress and lateral confinement) on the shear strength or, in this study, the cone penetration test (CPT) results. Addition of a surcharge over the ground changes the stress condition, and consequently, the CPT tip resistance. In this study, the results of different CPTs conducted before and after backfilling with various thicknesses in a land development project were reviewed while focusing on the trend of an increase in CPT penetration resistance due to the additional surcharge. Both pre- to post-fill stress ratios and soil type affect the rise in corrected $${q}_{c}$$ q c values after backfilling. Moreover, there has always been a sudden increase in $${q}_{c}$$ q c values around the pre-fill surface in all studied cases. In this study, another approach was derived from the reanalysis of CPT data from a specific site for predicting the post-fill corrected $${q}_{c}$$ q c from pre-fill results by considering the above-mentioned factor. Likewise, post-fill results were predicted by depth-normalized pre-fill CPT results using Robertson’s normalization method. The proposed approach in this study showed a better match with the site data compared to the normalization method, especially at and around the pre-fill surface.
Keywords
This publication has 30 references indexed in Scilit:
- Interpretation of cone penetration tests — a unified approachCanadian Geotechnical Journal, 2009
- Estimating liquefaction-induced ground settlements from CPT for level groundCanadian Geotechnical Journal, 2002
- Evaluating cyclic liquefaction potential using the cone penetration testCanadian Geotechnical Journal, 1998
- Use of CPTu to Estimate Equivalent SPT N60Geotechnical Testing Journal, 1993
- Seismic cone penetration test for evaluating liquefaction potential under cyclic loadingCanadian Geotechnical Journal, 1992
- Soil classification by the cone penetration test: DiscussionCanadian Geotechnical Journal, 1991
- Soil classification using the cone penetration testCanadian Geotechnical Journal, 1990
- Problems with interpretation of sand state from cone penetration testGéotechnique, 1989
- Calibration chamber tests of a cone penetrometer in sandGéotechnique, 1988
- The cone penetration test in sands: part II, general inference of stateGéotechnique, 1987